From: owner-ammf-digest@smoe.org (alt.music.moxy-fruvous digest) To: ammf-digest@smoe.org Subject: alt.music.moxy-fruvous digest V14 #4954 Reply-To: ammf@fruvous.com Sender: owner-ammf-digest@smoe.org Errors-To: owner-ammf-digest@smoe.org Precedence: bulk alt.music.moxy-fruvous digest Saturday, September 12 2020 Volume 14 : Number 4954 Today's Subjects: ----------------- Access the Internet anywhere with this incredible device! ["Be Safe" Subject: Access the Internet anywhere with this incredible device! Access the Internet anywhere with this incredible device! http://remedicial.today/h5UEJjP_zxePzLi6riRyYXUg2fkrKgxryx0Ny8j7VjovAliL http://remedicial.today/UyRhxA16SP6jxJx5OCWkPpGbLrxwyYcg3v--9apClXMQkt94 Incense mixtures can be extruded or pressed into shapes. Small quantities of water are combined with the fragrance and incense base mixture and kneaded into a hard dough. The incense dough is then pressed into shaped forms to create cone and smaller coiled incense, or forced through a hydraulic press for solid stick incense. The formed incense is then trimmed and slowly dried. Incense produced in this fashion has a tendency to warp or become misshapen when improperly dried, and as such must be placed in climate-controlled rooms and rotated several times through the drying process. Traditionally, the bamboo core of cored stick incense is prepared by hand from Phyllostachys heterocycla cv. pubescens since this species produces thick wood and easily burns to ashes in the incense stick. In a process known as "splitting the foot of the incense stick", the bamboo is trimmed to length, soaked, peeled, and split in halves until the thin sticks of bamboo have square cross sections of less than 3mm. This process has been largely replaced by machines in modern incense production. In the case of cored incensed sticks, several methods are employed to coat the sticks cores with incense mixture: Paste rolling: A wet, malleable paste of incense mixture is first rolled into a long, thin coil, using a paddle. Then, a thin stick is put next to the coil and the stick and paste are rolled together until the stick is centered in the mixture and the desired thickness is achieved. The stick is then cut to the desired length and dried. Powder-coating: Powder-coating is used mainly to produce cored incense of either larger coil (up to 1 meter in diameter) or cored stick forms. A bundle of the supporting material (typically thin bamboo or sandalwood slivers) is soaked in water or a thin water/glue mixture for a short time. The thin sticks are evenly separated, then dipped into a tray of incense powder consisting of fragrance materials and occasionally a plant-based binder. The dry incense powder is then tossed and piled over the sticks while they are spread apart. The sticks are then gently rolled and packed to maintain roundness while more incense powder is repeatedly tossed onto the sticks. Three to four layers of powder are coated onto the sticks, forming a 2 mm thick layer of incense material on the stick. The coated incense is then allowed to dry in open air. Additional coatings of incense mixture can be applied after each period of successive drying. Incense sticks produced in this fashion and burned in temples of Chinese folk religion can have a thickness between 2 and 4 millimeters. Compression: A damp powder is mechanically formed around a cored stick by compression, similar to the way uncored sticks are formed. This form is becoming more common due to the higher labor cost of producing powder-coated or paste-rolled sticks. ------------------------------ End of alt.music.moxy-fruvous digest V14 #4954 **********************************************