From: owner-ammf-digest@smoe.org (alt.music.moxy-fruvous digest) To: ammf-digest@smoe.org Subject: alt.music.moxy-fruvous digest V14 #4061 Reply-To: ammf@fruvous.com Sender: owner-ammf-digest@smoe.org Errors-To: owner-ammf-digest@smoe.org Precedence: bulk alt.music.moxy-fruvous digest Thursday, April 30 2020 Volume 14 : Number 4061 Today's Subjects: ----------------- Is This The WORST Food You Can Possibly Eat? ["Dr. Theo Diktaban" Subject: Is This The WORST Food You Can Possibly Eat? Is This The WORST Food You Can Possibly Eat? http://instanthard.guru/2oF2oficUQdAPsiq1UEDkmvNdwkUBJ_B1abu8vYaCqnlbLcX http://instanthard.guru/8JpRQHcaSu5DktjOUhKNFPHQbIgo5UxO3Z_nAo16FlNv0HcI measurements under ideal conditions or in the layer 2 data rates. This, however, does not apply to typical deployments in which data are transferred between two endpoints of which at least one is typically connected to a wired infrastructure, and the other is connected to an infrastructure via a wireless link. This means that typically data frames pass an 802.11 (WLAN) medium and are being converted to 802.3 (Ethernet) or vice versa. Due to the difference in the frame (header) lengths of these two media, the packet size of an application determines the speed of the data transfer. This means that an application that uses small packets (e.g., VoIP) creates a data flow with a high overhead traffic (low goodput). Other factors that contribute to the overall application data rate are the speed with which the application transmits the packets (i.e., the data rate) and the energy with which the wireless signal is received. The latter is determined by distance and by the configured output power of the communicating devices. The same references apply to the attached throughput graphs, which show measurements of UDP throughput measurements. Each represents an average throughput of 25 measurements (the error bars are there, but barely visible due to the small variation), is with a specific packet size (small or large), and with a specific data rate (10 kbit/s b 100 Mbit/s). Markers for traffic profiles of common applications are included as well. This text and measurements do not cover packet errors but information about this can be found at the above references. The table below shows the maximum achievable (application specific) UDP throughput in the same ------------------------------ End of alt.music.moxy-fruvous digest V14 #4061 **********************************************