From: owner-ammf-digest@smoe.org (alt.music.moxy-fruvous digest) To: ammf-digest@smoe.org Subject: alt.music.moxy-fruvous digest V14 #10316 Reply-To: ammf@fruvous.com Sender: owner-ammf-digest@smoe.org Errors-To: owner-ammf-digest@smoe.org Precedence: bulk alt.music.moxy-fruvous digest Tuesday, December 13 2022 Volume 14 : Number 10316 Today's Subjects: ----------------- Problems getting hard? Check out THIS... ["Male Enhancement" Subject: Problems getting hard? Check out THIS... Problems getting hard? Check out THIS... http://alphaextremenhancement.shop/hs2qSnt0q23BTfDdfyTclk0yMLdVokoIJg2hWZdX3A54DRhd1A http://alphaextremenhancement.shop/zNnfjEHyWeDtWmqEqUTKKd2OcKljiNOhunmpddv_iF7DDOGl7g or ironclad designers, there actually was an added advantage involved, becoming more pertinent in the later stages of the war when armor penetrating ordnance was developed, especially by the Union Navy who at war's end had developed shells capable of penetrating up to 9.5 inches (24 cm) of perpendicularly placed armor b hence the increase of armor thickness on Confederate ironclads; sloping increased effective armor thickness against armor piercing ordnance, which was typically fired on a flat trajectory. For example, the later 6 inches (15.2 cm) Confederate armor, sloped at 35 degrees, resulted in a 22 percent increase of effective horizontal armor thickness at 7.33 inches (18.6 cm). However, increasing the slope came at a cost as it meant adding more armor and heavier structural support b and thus more weight b to the casemate, while maintaining the original armor thickness. Armor was also applied to the part of the hull above the waterline. The casemate was often box-shaped, with armor and weight saving octagon shapes appearing in the later stages of the war. From the top of the casemate protruded a ------------------------------ End of alt.music.moxy-fruvous digest V14 #10316 ***********************************************